Views: 0 Author: Site Editor Publish Time: 2024-03-16 Origin: Site
Steps for Disassembling And Assembling of Squeezing Body on Oil Presser
In daily life, when we use the oil presser to processing edible oil, the oil press may not produce oil or produce little oil . This may be because there is a problem with the oil press's pressing strip, which needs to be disassembled and reassembled to solve this problem.
So how to disassemble and assemble the oil press's press bar? The following is a detailed introduction to the disassembly and assembly steps of the press bar:
Step1-6
1-Remove the nut from the press body 2-Remove the heating wire
3-Remove the heating pipe wires 4-Remove the wires here
5-Extracting and squeezing snails 6-Extract extract extract
Step7-11
7-Parking on the ground 8-Crush this place to squeeze strips
9-The first group of squeezing bars are in an open state
10-Remove the heating ring 11-Vertical pressing body
Step12-16
12-Cleaning and squeezing strips 13-Interval reinforcement ring
14-Place reinforcement ring 15-Props before placing the squeezing bar
16-Placing Squeezing Strips
Step17-Requirements for Placing Squeezing Strips
Please follow the instructions in the above diagram to install the squeezing strips. Install one 4-sided squeezing strip and one 6-sided squeezing strip in sequence.
Step18-22
18-Einforced squeezing bar 19-Reinforced squeezing bars
20-Reinstall the heating pipe 21-Completion of ground installation of the oil press body
22-Install into the oil press body
Step23-25
23-Tighten the nut 24-Install the squeezing shaft 25-Reinforcement
Step26-29
26-Press body assembly completed 27-Reinforcement
28-Installation of wiring 29-Installation of lower hopper and cover completed
Everywhere, all the steps have been completed.
After understanding the methods and steps to solve the problem, you can repair the oil pressing machine yourself, provide the machine's oil output rate, and reduce maintenance costs.